|
|
|
Features |
| |
- Special injection construction designed are benefit for plasticizing.
- By means of linear potentiometer (L/P) for injection, clamping and ejector unit the deviation is under 0.01mm.
- By use of PID temperature controller, which has limitations for screw cold starts, broken wire detection, temperature preservation, and etc... It can also control temperature
 1 C.
- Microprocessor controller with 4 stages injection, 3 stages holding pressure and 3 stages back pressure.
- Shut-down memorized device with 100sets mold data memory.
- Higher stability and lower defect in PET perform dimension.
|
|
|
|
